1999 ORMA PM-AIR 23-09 MEMBRANE PRESS [PM-010350] in Italy
- $33,783 (USD)
- PM-AIR 23-09
Designed for lamination of pre-shaped & glued panels with Veneer, PVC & Polypropylene films with the use of a membrane; works well with thick PVC and especially well with Veneer since it applies positive, direct pressure to the profiled/contoured surface. This concept allows for cycle times as short as (1.5 - 2) Min depending on the Veneer thickness.
-- Manual loading/unloading tray "flame cut" steel frames; platen dimensions: 2300 mm X 900 mm (90.5" X 35.4"), front loading in the 90" direction, total daylight opening approx. 10", max. workpiece thickness 2-1/8", max. have 160 tons of pressure that generate a specific pressure
-- Lower platen with embedded membrane,; membrane filled with "silicone" type heating medium which is heated by lower platen; this lower and the top steel platen are drilled for hot water or thermal oil heating, currently setup for diathermic oil heating; approx. 130Ã‚Â° operating temperature.
-- Design feature: (8) Large dia. upstroke hydraulic cylinder/rams 100 mm Dia. (centered in a row), move the lower mobile press platen w/membrane into the closed position and locks it in place with hydraulic pressure cylinders.
-- Integrated 25 kW electrical resistance diathermic oil heating system; fully integrated hydraulic system and free standing separate electrical operator control panel.
--Note: EX-FACTORYâ€™s Logistic Department is experienced and setup to provide â€œFull Service Logisticsâ€� from Overseas Suppliers to your Door. â€¦Packaging, Container Loading, Ocean Freight, Marine Insurance (door to door), US or Canadian Customs, Duty and domestic shipping to your Plant Door.â€�
Get email updates for Orma PM-AIR 23-09