ATLAS Copco distributor
offer you :
Last further brought to the range of hydraulic equipment from Atlas Copco: the magnetic magnet, a range of effective tools for the recycling factories, scrap yards and demolition sector.
HM 2000 E
Hydraulic magnets allow fast and easy to separate the iron and steel used in concrete rubble for recycling. Just installed on the grapple or the existing shears, they require no additional generator or electrical cable at the carrier. Two hydraulic magnet versions are available: fixed magnet (F) or moving magnet with chain (M). The load capacity is between 280 and 7500 kg.
Shorter cycles for reduced fuel consumption
Atlas Copco generator digital control technology can reduce up to 25% the magnetization and demagnetization cycle compared to the traditional magnet controllers. This implies a fuel consumption reduction. The digital controller also protects the hydraulic magnet against damage caused by a short circuit, overheating or a revolution of excessively high or low generator.
Durable, compact design and easy operation
All major components of the hydraulic magnet are integrated into a compact design. A sealed steel housing protects the magnetic coil against mechanical impacts and moisture. An outer ring Hardox protects against wear. The integrated multifunction diagnostic panel in a waterproof body indicates the current operating status and possible failures for troubleshooting.
Less damage to equipment on the site
The collection of ferrous materials in demolition rubble using hydraulic magnets not only increases profitability but also reduce the risk of damage in crushers, conveyor belts, tires and other equipment.
do not hesitate to contact us
Get email updates for Atlas-Copco HM 1500F-HM1500M-HM2000F-HM2000M