Hainesport, NJ


Stock number:


Cleaver brooks packaged firetube boiler; model cb200-100, constructed in 2007 in accordance with the asme code; section i,. for a design pressure of 150 psig and national board certified. Unit is a four-pass dryback design with 500 square feet of fireside heating surface. The shell is insulated with two inches of compressed fiberglass and covered with a heavy gauge sheet steel casing. The fully modulating forced draft burner is integrally mounted, piped and wired on the boiler front allowing for ease of flame observation, set-up and maintenance. Valve trim, controls and auxiliary equipment include:
*water column with sight glass, gauge cocks, tricocks and blowdown valves
*primary low water cut-off and feed pump control; mcd&m no. 193a
*secondary low water cut-off; warrick probe type
*boiler valve trim including; feedwater stop and check valving, blowdown and blow-off valves, vent valve and safety relief valves per asme code
*front and rear hinged covers
*pressure gauge and stack thermometer
*fuel pump and motor drive with relief valve and suction strainer, shipped loose
*boiler/burner control center consisting of a fireye e-110 primary flame control and detector, motor starters, relays, limit switches, alarm bell, indicating lights, control circuit *transformer and manual potentiometer for manual firing rate adjustment
*steam pressure limit switches; operating limit, safety limit with manual reset, low fire hold control and modulating steam pressure controller
*atomizing air compressor and motor drive with inlet air filter and lube oil cooler, mounted and wired
*fm insurance & ge cap global approvals,
*csd-1 safety code standards and u.l. Labeling
steam – 6″ x 300# natural gas – 2.0″ npt blowdown – 1.25″ npt electric – 460v/3/60
feedwater – 1.25″ npt #2 oil, s & r – 0.75″ npt blow-off – 1.0″ npt exhaust – 12″ dia.
dimensions: 15′ 07″ long x 5′ 06″ wide x 6′ 00″ high. Shipping weight – 9,500 lbs, operating weight – 14,600 lbs.