Used 54″ wide nrm sheet extrusion line including 4.5″ extruder, sheet downstream, brown model 42p thermoformer and brown model. tp30 trim press. Line specifics are as follows:
– 4.5″ nrm 24/1 l/d single screw extruder, driven by a 200 hp motor. Capacity reported at 300kg per hour. Includes temperature control panel, hydraulic screen changer, water cooled cooling system, top vent, and direct connected 200 hp dc motor with scr control.
– downstream consists of:
approximately 15hp melt pump, co-ex block (no co-ex extruder currently), and 43″ wide edi ultra flex r75 sheet die. Previously used at 50mil thickness on pp, hips, mips.
– 54″ nrm 3-roll vertical chrome roll stack, chain driven with approximately 8′ cooling conveyor and dip coating station prior to rubber pull rolls.
– thermoformer and trim press consisting of the following:
brown model 42p chain fed, inline thermoformer for maximum 40″ wide mold. Has calrod type heat, 6 zones, and siemens control. Rated at 18 cycles per minute. Also included is a brown model tp30 trim press including a 40″ wide window opening, rated at 100 cycles per minute.
– included in package is wortex model up-755-d under-the-press trim grinder with approximately 15 hp motor. Also included is vacuum pump and hydraulic pumping system.
still installed as operated and can be seen in operation. Asking price includes loading onto flatbed truck or, for overseas shipment, loaded and lashed into container.
Get email updates for extruders