Dundee, FL
Ace Center MF-46VA OSP-E100M
Spindle Taper:
CAT #40


Integrated 180 Degee 2 Pallet Changer Chip Conveyor 15,000 RPM Spindle Option High Pressure Coolant Thru the Spindle Renishaw Probing Hand Held Remote Jog Handle Machine Status Condition Lights RS-232 Port Interface Rigid Tapping 32 Position Side Mount Tool Changer 3.5" Floppy Disk Drive Interface Helical Interpolation Multi Tap Transformer Shower Coolant System Stevens Engineering Tooling Plates Hydraulic Work Holding Package w/ Foot Pedal Less than 3,000 Run Hours, only 700 since it Was Purchased Used in 2010 and Reconditioned at that time to Factory Specs
Spindle taper:
CAT #40
X-axis travel:
Y-axis travel:
Z-axis travel:
Machine weight:
21,340 lbs.
Spindle speeds:
50 - 15,000 RPM
Tool change time:
2.4 seconds
Machine dimensions:
129" x 92"
Table load capacity:
880 lbs.
Maximum spindle torque:
147 ft./lbs.
Tool magazine capacity:
32 Position ATC
Maximum cutting feedrate:
1260 IPM
Rapid traverse rates x, y / z:
1574/1260 IPM
Table size / number of pallets:
29.95" x 18.12" / 2 Pallets
Maximum tool diam./length/weight:
5.98"/11.81/26.4 lbs.
Spindle motor 30 minutes/continuous:
35 / 25 HP


The Okuma Ace Center MF-46VA adopts a powerful double column structure together with an integral rotary 2-APC for high accuracy and high production in a compact footprint. Okuma’s Thermo-Friendly Concept is standard on this machine for unrivaled dimensional stability over long continuous runs.  The Okuma MF-46V is equipped with a high speed; high power 8,000 rpm spindle with a 15 hp VAC liquid cooled integral motor. This model incorporates a six-second rotary two pallet and a high-speed 20 position automatic tool changer and a 1,574 ipm rapid traverse, resulting in a powerful production capability.
As machines become more complex, there is more room for human error.  Okuma’s Collision Avoidance System (CAS) integrates 3D modeling of their machines, blanks and tooling with the power of the THINC-OSP Control to create a virtual machine. By running the real-time virtual application seconds ahead of the actual cutting, problems can be detected early and the machine stopped before a...