2002 COLOMBO PF PC5 MEMBRANELESS

2002 COLOMBO PF PC5 MEMBRANELESS VACUUM PRESS [PM-010378] in Germany

Location:
Germany
Price:
$68,690 USD
Manufacturer:
Colombo
Model:
PF PC5

Specifications

Condition:
used
Year:
2002
Recnum:
PM-010378
Comments:
This COLOMBO "PF PC 5" Automatic Vacuum Shuttle Press System includes an Overhead Vacuum Destacker!
Machtype:
MEMBRANELESS VACUUM PRESS
Condition info:
(6-8) Very good condition [7]
Current status:
Active
Elect./voltage:
380/400 V, 50/60 Hz, 3 Ph.
Appr. repl. cost:
245000

Description

COLOMBO "PF PC 5" Automatic Vacuum Shuttle Press System for cabinet doors using thermoformed materials - with Vacuum Destacking.

-- The Press is designed for lamination of pre-shaped and glued panels with PVC & Polypropylene films without the use of a membrane. This concept allows for cycle times as short as (1-1/2 - 2) Min depending on the 0.3 - 1 mm max. film thickness.General & Specifications:

-- Platen dimensions: 2,850 mm x 1,296 mm (112" x 51") usable platen area.

-- End loading with "synchronized in-and-out" shuttle mylar belt table, shuttle loading tray runs on mylar belt & "THK" precision linear guides with automatic movement in-and-out of Press for continuous operation.

-- Solid steel top & bottom platens through bored for thermal oil flow, upper press platen opens-and-closes with pressure from large dia. down stroke hydr. cylinders with 4-1/2" in diameter; 380 metric tons overall pressure.

-- Electrically heated thermal oil heating system, max. platen temperature 100 deg. C.

-- Twin-tank vacuum system with high capacity accumulator tank for very rapid draw down of the film over the shaped panels, mounted on top of press.Operation & Features:

-- Separate electrical control cabinet houses the programmable SIEMENS "SPS" controller and operator control panel, and features error diagnostic via phone modem.

-- The concept of working without a membrane allows for forming the film into deep and vertical sided profiles, very small profiles like vein lines, and lipped profiles which are not possible using a membrane.

-- Working without a membrane permits the higher working temperatures required for laminating the environmentally preferred polypropylene films and saves the expense of regularly replacing damaged/worn membranes.

-- Complete with: 6-Roll PVC dispensing system w/trimmer with 6-roll and 57" width capacity.Note: EX-FACTORY’s Logistic Department is experienced and setup to provide “Full Service Logistic� from Overseas Suppliers to your Door. …Packaging, Container Loading, Ocean Freight, Marine Insurance (door to door), US or Canadian Customs, Duty and domestic shipping to your Plant Door.