1995 DIMTER HK800-K/200 FINGER JOINTING

1995 DIMTER HK800-K/200 FINGER JOINTING SYSTEM [FJ-010617] in Germany

Location:
Germany
Price:
$58,800 USD
Manufacturer:
Dimter
Model:
HK800-K/200

Specifications

Condition:
used
Year:
1995
Recnum:
FJ-010617
Comments:
Unusual opportunity to own the best for a fraction of new price!
Machtype:
FINGER JOINTING SYSTEM
Condition info:
(6-8) Very good condition [7]
Current status:
Active
Elect./voltage:
440 V, 60 Cy, 3 Ph.
Appr. repl. cost:
400000

Description

High cap. vertical finger jointer with the following equipment and specifications:

-- Compartment conveyor, subdivided into (3) compartments, provides incoming blocks to the shaper section; Conveyor is 3,000 mm long x 2,000 mm wide; each compartment is 800 mm wide and powered by a 1.5 kW motor. - Infeed conveyor to Finger Jointer is 800 mm wide x 2,000 mm long and powered by a 0.37 kW motor.

-- Packet Profiler, type "HK800K/200" for profiling & glue application: Designed for simultaneous machining of (2) packets, facing each other and with 1-sided glue application during the 2nd profiling operation; (2) chippers to allow proper adjustment of finger length. - Cutters mounted directly on motor shaft; glue spread by profile roller & glue pump; packets clamped from top & sides during machining. (2) 7.5 kW Motors for chipper drive, (2) 18.5 kW motors for 50 mm dia. x 2,920 RPM cutterhead spindle, 0.37 kW motor for glue wheel. Conveyors at infeed & outfeed of profiler each 2,000 mm long x 800 mm wide.

-- Universal Turning & Infeed Station: Roll conveyor to transport profiled packets with glue applied from the profiler to the packet separation station; allows for "front face alignment" of varying block lengths at the final stop on the roller conveyor; cross-conveyor transfers the separated blocks to the infeed of the press section; roll conveyor is 2,000 mm long x 800 mm wide and the driven cross- conveyor also serves as a "buffer zone". A roll conveyor with jump-rolls directs blocks into the press infeed section where blocks are centered with rolls & side centering device. Roll drives are approx. 3.5 kW.

-- Press Section type "PN10/6 - 6.1" (20'): Profiled blocks are assembled into an endless ribbon, transported to an adjustable length stop with fast setting of desired lengths, cut to the final length, and fed to the pressing zone. Pressing of final lengths via front squeeze clamp with pneumatic top & lateral guides to assure straight final product. Press discharges assembled lengths onto supporting arms and operates while cross-transferring the previous part because of a 2-level operation; Press generates 100 kn (10,000 kp) pressure and is adjustable according to lumber cross-sections; 6,100 mm pressing lengths; saw motor & hydraulic drive system are both 3 kW.

-- Stacking Arm type "Z1": For automatic stacking of finished lengths to form a timber packet without stacking sticks; stacking arms are integrated into the press section and allows for finished lengths to be pushed onto the stacking arms; once the required number of parts per layer is achieved, the arms retract and the layer is placed on the stacking table. Stacking arms quickly return to the starting position to accept the next piece. Stacker is complete with (5) arms and will accept parts 6,100 mm long x 1,000 mm wide.

-- Unit height is dependent on Scissors Lift and if the hoist is in pit or surface mounted; working height of the list is controlled by a photo cell.