Top Seller
COLE-TUVE / SAHINLER SRS-5-110 5'
Location:
Port Orange, FL
Manufacturer:
Sahinler
Model:
SRS-5-110
Weight:
2,640 lbs.

Specifications

Condition:
new
Stock number:
SRS-5-110
Motor hp:
3
Warranty:
1 YEAR
Electrics:
3/60/220/440
Rolling speed:
10' per minute
Manufacturer 2:
Cole-Tuve
Diameter of all rolls:
4.33"
Weight- approximately:
2,640 lbs.
Overall bending length:
61"
Dimensions approximate, lxwxh:
107" x 30" x 40"
Subcategory:
Rolls
Subcategory 2:
Plate bending

Description

ITEM: 5' x 11 ga Initial-Pinch Sheet & Plate Bending Roll
MAKE: COLE-TUVE / SAHINLER®
MODEL: SRS-5-110
Product Features
COLE-TUVE Single-Initial Pinch Rolls utilize a design that has gained worldwide acceptance. Strong cast-iron frames are used on all sizes for rigidity and stability. The rolls are journalled in long-life bronze bearings. The upper and lower rolls are driven by a brake-motor through heavily proportioned gearbox, producing a single rolling speed. The lower front roll, which is used for clamping the workpiece, and the rear roll, which is used for setting the bending radius, are each adjusted by a single handwheel and both handwheels are conveniently located for ease of operation. The use of a single handwheel for each adjustment avoids the operator's having to move from one end of the machine to the other to adjust each roll (as is necessary on some other machines). A secure locking device keeps the upper roll in proper position during rolling and is easily released to allow the roll to be swung out for removal of the rolled part. A cone bending attachment is standard equipment and a movable foot control on a trailing lead add to operator convenience and ease of operation. The rolls are grooved for rolling three sizes of round bars. When delivered, the machine needs only to be connected to a power supply and is ready to operate
Cast iron frames for rigidity and stability
Brake-motor for rapid stopping of rolls rotation
Upper and lower rolls driven
Lower and rear rolls adjustable
Convenient handwheels for adjustment
Upper roll swings out for removal of completed cylinder
Locking device keeps the roll in position during rolling
STANDARD EQUIPMENT
Low voltage at the control
Movable foot control
Emergency stop button on the control
Emergency stop wire at front and rear of the machine
Cone bending attachment
Tiltable rear roll
Grooves in rolls for 3/8", 1/2" and 5/8" round bar
Scale to indicate position of the rear roll