Top Seller
BAILEIGH R-H85 Double-Pinch 3" ANGLE
Location:
McClellan Park, CA
Model:
R-H85

Specifications

Condition:
new
Stock number:
6720
Pinch:
Double
Power:
220V / 3-phase
Lower roll dia:
9.65"
Shaft diameter:
3.15"
Digital readout:
Yes
Roll adjustment:
Hydraulic
Shipping weight:
3,550 lbs
Subcategory:
Benders
Subcategory 2:
Angle rolls

Description

Model: R-H85
Roll Adjustment: Hydraulic
Pipe Capacity: Size: 3" (sch. 40) / Min. Dia.: 68"
Round Tube Capacity: Size: 4" (.120") / Min. Dia.: 118"
Square Tube Capacity: Size: 2.75" (.157") / Min. Dia.: 118"
Solid Round Capacity: Size: 2.375" / Min. Dia. 40"
Flat Bar Easy Way: Size: 5" (1") / Min. Dia. 24"
Flat Bar Hard Way: Size: 4" (.787")/ Min. Dia.: 83"
Angle Iron Capacity: Size: 3.375" (.250")/ Min. Dia.: 68"
Shaft Diameter: 3.15"
Lower Roll Dia.: 9.65"
Pinch: Double
Digital Readout: Yes
Power: 220V / 3-phase
Shipping Weight: 3,550 lbs.
DESCRIPTION:
Baileigh Industrial's R-H85 double pinch angle roll machine
is a great choice for a roll bender when looking to reduce
scrap. The R-H85 is considered a double pinch roll bender
since the top roll is fixed and the two bottom rolls are on
independent hydraulic cylinders with encoders that
communicate to the DRO programmers for exact positioning of
each roll. The double pinch design helps minimize those
money wasting pieces of straight that are commonly found at
the start and finish of the bend by allowing the operator to
pre and post bend the material.
The R-H85 is capable of bending up to 3" Schedule 40 pipe
and 3-3/8" x 3-3/8" x 1/4" angle iron. It is built to last
using heavy steel plate that is bolted and welded for
further structural strength allowing for no flex at full
capacity. This angle bending roll comes standard with an
industrial grade hydraulic transmission that drives all
three rolls. The same hydraulic system controls the movement
of the angle lateral guide rolls as well. These rolls help
keep the material from twisting while being bent.
The operator pedestal controls all movement of the machine
and the integrated digital readout shows positioning of the
bottom rolls. There is also a stop that can be set for each
roll for repeatability when doing production runs.