- Stock number:
- 2 HP
- 1270 lbs
- 50" X 12 Gauge (Mild Steel)
- 220/440Volt, 3 Phase, 60 HZ
- 79"L X 33"W X 45"H
- Rolling speed:
- 11-1/2' Per Minute
- Diameter of rolls:
- Overall bending length:
- Machine Tools equipment in United States
Capacity: 50" X 12 Gauge (Mild Steel)
Diameter of Rolls: 3.93"
Overall Bending Length: 49.21"
Rolling Speed: 11-1/2' Per Minute
Motor: 2 HP
Electrics: 220/440Volt, 3 Phase, 60 HZ
Dimensions: 79"L X 33"W X 45"H
Weight: 1270 lbs.
-Cone Bending Attachment
-Electrics for 3/60/220/440
-Low Voltage At The Controls
-Portable Push Button Control &Emergency-Stop Palmbutton
-Handwheels For Roll Adjustments
-Lockable Swing-Out Upper Roll
-(3)Grooves For 3/8", 1/2", And 5/8" Round Bar
-Scale To Indicate The Positions Of The Rear Roll
The Model RM Initial-Pinch Rolls are also called Slip
Rolls. Used for bending lighter sheet materials, they are
built for durability and efficiency, while still being
affordable and easy to operate. All sizes use strong cast-
iron frames for rigidity and stability.
The roll shafts are journalled in long-life bronze
bearings. The upper and lower rolls are driven by a brake-
motor through a heavily proportioned gear assembly,
producing a single rolling speed and effecting prompt
stopping of the rotation of the rolls.
The lower front roll, which is used for clamping the work-
piece, and the rear roll, which is used for setting the
bending radius, are each adjusted by a single handwheel.
Both handwheels are conveniently located for ease of
The rear roll can be readily tilted to facilitate the cone
bending procedure. A secure locking device keeps the upper
roll in proper position during rolling and is easily
released to allow the roll to be swung out for removal of
the rolled cylinder. The rolls are grooved for three sizes
of round bar. When anchored and connected to a power
supply, the machine is ready to operate.
Get email updates for SAHINLER RM-4-100