Taylor Water Well Drilling Rig
100 Ton 60’ mast
40” Single Drum Drawworks (Originally a double drum machine but 1 drum has been removed, so currently offered as a single drum.)
Drum is hydraulic drive
CAT C15 Diesel Engine
Venturetech XK-150 Rotary Head (150Ton)
Top head and with Garner Denver table drive
Mounted on a 3 axle Trailer
Has been sitting since 2008, but besides the expected effects of being idle, is in good condition overall, and with a full service and repairs would be ready for drilling again.
Taylor Company inspected and also recommends the following modifications if using for water well Drilling:
Add mechanical drum (currently has hydraulic drum only)
Remove and lower table structure in rear which is high for BOP, re-pin mast for water well drilling convenience.
Offered as a package with approximately 5300 ft. of Drill Pipe, 600 f. of Drill Collars, Farr Power Tongs, Detroit S60 Skidded Generator Set / Accumulator, Large Duplex Mud Pump powered by CA 3412 skid mounted, 2 mud tanks, Fuel Trailer with 2 Fuel Tanks, Doghouse Trailer with tool room, offices, and locker room.
Located in Eastern Region, USA
Get email updates for Taylor Water Well Drilling Rig