Top Seller
Anritsu MS610C Portable Spectrum Analyzer,
Location:
Elgin, IL
Model:
MS610C

Specifications

Condition:
used
Division:
Electronic Test Equipment
Zero span:
Yes
Form factor:
Benchtop
Probe power:
No
Maximum span:
1 GHz
Minimum span:
0.1 MHz
Trigger modes:
Freerun,TTL
Condition info:
Refurbished
Input impedance:
50 Ohm
Maximum dc input:
100 V
Maximum frequency:
2 GHz
Minimum frequency:
9 kHz
Maximum sweep time:
10 s
Minimum sweep time:
10 ms
Noise source driver:
No
Maximum safe ac input:
20 dBm
Video bandwidth steps:
1/10/100
Maximum video bandwidth:
10 kHz
Minimum video bandwidth:
100 Hz
Cal output connector type:
BNC(f)
Resolution bandwidth steps:
1/3/10
Connector type (main signal):
Type-N(f)
Maximum resolution bandwidth:
1 MHz
Minimum resolution bandwidth:
1 kHz
Maximum amplitude uncertainty:
1.5 %
Maximum single-side-band noise:
-70 dBc/Hz
Maximum displayed average noise:
-115 dBm
Subcategory:
Analyzer
Subcategory 2:
Spectrum analyzer

Description

Product Overview:
The
Anritsu MS610C spectrum analyzer
is a wide band, very sensitive receiver. It works on the principle of "super-heterodyne receiver" to convert higher frequencies (normally ranging up to several 10s of GHz) to measurable quantities. The received frequency spectrum is slowly swept through a range of pre-selected frequencies, converting the selected frequency to a measurable DC level (usually logarithmic scale), and displaying the same on the CRT of the Anritsu MS610C. The CRT displays received signal strength (y-axis) against frequency ( x-axis).
Some applications for Anritsu MS610C Spectrum Analyzers include Site Monitoring: Verify that the frequency and signal strength of your transmitter is accurate. Interference: Before a system is installed you use a Anritsu MS610C spectrum analyzer to verify that the frequencies (you plan to use) are not occupied or if the presence of a very strong signal will interfere with your new setup. Interference can be created by a number of different situations. Other tests that utilize the Anritsu MS610C spectrum analyzer features include antenna isolation, co-channel interference, adjacent channel power, occupied bandwidth, intermodulation, microwave or satellite antenna alignment, and characterization of components.
Specifications:
Form Factor: Benchtop
Input Impedance: 50 Ohm
Minimum Frequency: 9 kHz
Maximum Frequency: 2 GHz
Zero Span: Yes
Minimum Span: 0.1 MHz
Maximum Span: 1 GHz
Minimum Sweep Time: 10 ms
Maximum Sweep Time: 10 s
Minimum Resolution Bandwidth: 1 kHz
Maximum Resolution Bandwidth: 1 MHz
Resolution Bandwidth Steps: 1/3/10
Minimum Video Bandwidth: 100 Hz
Maximum Video Bandwidth: 10 kHz
Video Bandwidth Steps: 1/10/100
Maximum Single-Side-Band Noise: -70 dBc/Hz
Maximum Safe AC Input: 20 dBm
Maximum DC Input: 100 V
Maximum Displayed Average Noise: -115 dBm
Maximum Amplitude Uncertainty: 1.5 %
Trigger Modes: Freerun,TTL
Connector type (main signal): Type-N(f)
Cal Output Connector Type: BNC(f)
Probe Power: No
Noise Source Driver: No