Used heat exchangers inc

- 212 listings found
Sort by Price: Low to High | High to Low
  • ITT Industries Inc. P14

    • Manufacturer: ITT Industries Inc.

      Serial number: 170787-01, mfg date: 2012. installed with 27 standard plates providing a total surface area of 40.36 sq. ft. nitrile gasketed, 2"npt male connections. plate material: 316 stainless steel, plate...

      $1,800 (USD)
      Millwood, WV, USA
    • IPEC Inc. 2BU16-120

      • Manufacturer: IPEC Inc.

        325 square feet of areashell & tube rated for 150 psi @ 650°f.previously used in thermal oil service, pressure cleaned after removaldimensions: 175" x 28" x 34", 2700lbs

        $15,000 (USD)
        Millwood, WV, USA
      • 94 Square Feet Baeuerle And Morris Inc. Shell Tube - Stainless Heat Exchanger #216271

        • Manufacturer: Baeuerle
        • Capacity: 94 SQUARE FEET / 9 SQUARE METER

        94 sq.ft., bimetallic sb111cda706 (85% cu) over 304 ss tubes, 304 ss heads, cs shell, horizontal heat exchanger. manufactured by baeuerle and morris inc. serial # 26030, nb # 1367. shell side rated for 50 psi at ...

        No price
        West Windsor Township, NJ, USA
      • Sq Ft Shell And Tube Inc. Shell Tube - Stainless Heat Exchanger #210984

          • Capacity: SQ FT /

          577 sq. ft., 316 ss tubes, 304 ss tube sheet, 304 ss shell, cs heads, horizontal heat exchanger mounted on saddles. type beu, 2 pass tubes, one pass shell. shell rated for 75 psi at 280 degrees f. tubes rated for...

          No price
          West Windsor Township, NJ, USA
        • Bos-Hatten Inc. Not Applicable 13215

          • Manufacturer: Bos
          • Capacity: 2369 Sq Ft

          Used 2,369 sq.ft. vertical condenser. mfg by bos-hatten. carbon steel shell rated fv/75 psi @ 250 deg f. 304 stainless steel tubes rated fv/75psi @ 250 deg f. national board #3937, serial #86-2921. built 1987.

          No price
          Red Bank, NJ, USA
        • Xchanger Inc. heat exchanger used to heat and cool low pressure gas streams

          • Manufacturer: XChanger

            Xchanger inc. heat exchanger used to heat and cool low pressure gas streams. model c-100-2. typical pressure 15 psi (1 bar). air in 2", air out 2". tube inlet 3/4", outlet 1.5". used to heat/cool/dehumidify by...

            No price
            Penns Grove, NJ, USA
          • Weldon Incorporated 2ST8-96 13531

            • Manufacturer: Weldon Incorporated
            • Capacity: 75 Sq Ft

            Used 75 square foot 316 ss shell and tube heat exchanger by weldon inc. model 2st8-96, serial # 3402. features two pass design with (50) .750" od 316 ss tubes x 94" long, national board rated (# 3809) for full va...

            No price
            Red Bank, NJ, USA
          • Qty. (3) each: 15 Sq.Ft. HELITHERM steam to water heat exchanger

            • Manufacturer: AERCO INTERNATIONAL INC.

              Qty. (3) each: 15 sq.ft. helitherm steam to water heat exchanger. steam is primary or tube side fluid and water is secondary or shell side fluid. shell is 10.5" dia x 34.75" l. has 3 coils.

              No price
              Penns Grove, NJ, USA
            • 2009 Heat Exchanger Design Inc. 31-E-188

              • Manufacturer: Heat Exchanger Design Inc.

                Shell & tube heat exchanger, rated at 4.02 mmbtu/hr, hp solvent 36/102, lean solvent 121/46f. shell & tube, tema type bfu, 5861 sq ft, 0.75/0.083", 38250 #. manufactured by heat exchanger design in 2009 - ran onl...

                No price
                Soperton, GA, USA
              • Plate Heat Exchanger

                • Manufacturer: Waukesha Cherry Burrell

                  Waukesha cherry burrell estimated 549 sq. ft. surface area stainless steel plate heat exchange. model t60ch-al. built 10-26-01 by thermaline, inc., auburn, wa. serial number 5000. the heat exchanger has a maximum...

                  No price
                  Louisville, KY, USA