Used machine jack

1985 MOBILE B57 AUGER DRILL RIG #10431T

Rig manufactured 1985, Ford 300 inline 6 engine, 4 speed transmission, 8000 lb winches, Moyno water pump, splines on cathead stripped, few leaks in control panel, swing out under deck and rear rack, rod storage b...

1993 ACKER SOIL MAX AUGER DRILL RIG #3298Td

Manufactured 1993 (one owner) angle drilling, Deutz diesel 6 cylinder, air cooled, electric start, 8 speed (11,600ft lbs torque) quick disconnect chuck, 2" swivel attachments, roller chain, 4-5/8 hollow bore spin...

BUCYRUS ERIE 22W CABLE TOOL DRILL RIG #8981T

• Manufacturer: Bucyrus-Erie
• Model: 22W
• Mast Height: 12.19 m

Propane deck engine, cathead, 3 line machine, 800’ of mainline, mounted on 1972 Ford truck with gas engine, 1 front and 2 rear hydraulic leveling jacks Tooling: drill stems, drill bits ranging from 6” to 8” and (...

1974 SPEEDSTAR SS-15THH DRILL RIG #5497T

Manufactured 1974, Leroi 600 cfm air compressor, no mud pump (but plumbed for one), mounted on 4 axle Crane Carrier, 350 Cummins diesel engine, PTO, Fuller transmission, 3 hydraulic leveling jacks, no rod box, no...

2022 DIEDRICH D50 AUGER DRILL RIG #3388T

• Manufacturer: Diedrich

Manufactured 2022 (delivered 2023), John Deere 4-cyl engine, (3) winches plus wireline wince, 3L6 Moyno pump, SPT hammer, breakout, 120 gal water tank, mounted on rubber track carrier, remote control, fold down w...

BUCYRUS ERIE 22W CABLE TOOL DRILL RIG #7315T

• Manufacturer: Bucyrus-Erie
• Model: 22W
• Mast Height: 12.19 m

Mounted on 1979 Ford Louisville truck with gas engine, 6 cylinder Hercules gas deck engine, 2 rear manual jacks, fully tooled (3” and larger), sitting since 2019, does not run Price: $16,500 - Illinois BUCYRUS ER...

1972 CME 750 AUGER DRILL AND TRUCK/TRAILER PACKAGE #5897T

Manufactured 1972, Moyno pump, mounted on ATV buggy carrier powered by Ford 300 6-cyl gas engine, PTO, CME auto hammer, cathead, in/out slide base, 3 leveling jacks, auger racks, large tool box, water tank, 3 win...

Northtech SPS10-3 Sliding Panel Saw

• Manufacturer: Northtech

NT-SPS10-3 SLIDING PANEL SAW MAIN MOTOR HP: 7.5 HP VOLTAGE, FREQUENCY: 230/460 Volt 60Hz PHASE: 3 Phase AMP REQUIREMENT: 16.7 / 8.35 Amps FEED SYSTEM: Sliding Table DRIVE SYSTEM: Manual Push of Sliding Table ELEV...