Used packaging

Mohr Extrusion Press | Mohrtek MEP-120L

• Manufacturer: Mohr

Units is USED. Some minor scratching/blemishes/streaking can be seen on the surfaces of the unit, but is not affecting the unit intended use. Unit is being sold AS-IS, WHERE-IS, AS-SHOWN. Pictures are of the actu...

3.5" Davis Standard Cold Feed Rubber Extruder

• Manufacturer: Davis-Standard

3.5" Davis Standard Cold Feed Rubber Extruder Used 3.5" Davis Standard cold feed rubber extruder, model 35IN35, electrically heated, water cooled barrel, powered roller strip feeder section, Thermatic gearbox, 17...

3 Roll Sheet Stack Davis-Standard 1.25" Extruder Line

• Manufacturer: Davis-Standard

3 Roll Sheet Stack Davis-Standard 1.25" Extruder Line 10" 3 roll sheet stack line, consisting of: 1.25" Davis Standard extruder, model DSPW-125V-H24, 24:1 L/D, electrically heated, water cooled with circulation p...

10" Ribbon Slot Die

10" Ribbon Slot Die Used 10" Ribbon slot die, fed from 1.5" heated feed throat, 8.5" diameter feed side.

19 MM APV Baker Perkins Twin Screw Extruder, Model MP-19-TC

• Manufacturer: APV

19 MM APV Baker Perkins Twin Screw Extruder, Model MP-19-TC Used 19 MM APV Baker Perkins twin screw co rotating extruder, model MP-19-TC, 19 mm diameter screws, 25:1 l/d, electrically heated, water cooled barrel,...

Bonnot Single Screw Extruder

• Manufacturer: Bonnot

Bonnot Single Screw Extruder Used Bonnot single screw extruder, model 2", stainless steel barrel and screw, with approximately 2" diameter X 10" long jacketed barrel with Pin and Grooving barrel, 6" x 4.5" feed t...

Fuji Paudal LCI Twin Dome Extruder Screen, .8 mm

• Manufacturer: Fuji Paudal

Fuji Paudal LCI Twin Dome Extruder Screen, .8 mm Used Fuji Paudal LCI TDG-110PA Twin Dome Extruder Screen, .8 mm.

53 mm W & P Twin Screw Extruder, 40:1 L/D

• Manufacturer: WP

53 mm W & P Twin Screw Extruder, 40:1 L/D Used Werner & Pfleiderer twin screw extruder, model ZSK53, 53mm twin screws, co-rotating, 40:1 L/D, electrically heated, water cooled barrel with (7) barrel sections, 60 ...

1.25" Killion Extruder, 24:1 L/D, 5 HP with Bath

• Manufacturer: Killion

1.25" Killion Extruder, 24:1 L/D, 5 HP with Bath Used 1.25" Killion single screw extruder, 24:1 L/D, electrically heated, air cooled barrel, jacketed feed section, driven by 5 hp DC motor drive, on stand with co...

Fuji Paudal LCI Twin Dome Extruder Screen, .8 mm

• Manufacturer: Fuji Paudal

Fuji Paudal LCI Twin Dome Extruder Screen, .8 mm Used Fuji Paudal LCI TDG-110PA Twin Dome Extruder Screen, .8 mm.

4.5" NRM Extruder, 20:1 L/D, 150 HP

• Manufacturer: NRM

4.5" NRM Extruder, 20:1 L/D, 150 HP Used 4.5" NRM Pacemaker extruder, 20:1 L/D, electrically heated, air cooled, 150 HP DC motor with SCR, control panel with 4 barrel, 1 die zone with temperature controllers.

85 Cu Ft (2,400 Liter) Welex Cooler, Model 2400 HC, S/S

• Manufacturer: Welex

85 Cu Ft (2,400 Liter) Welex Cooler, Model 2400 HC, S/S Used 85 cu ft (2,400 liter) Welex cooler, model 2400 HC, stainless steel construction, with bolt on paddles, belt driven by 30 hp, 230/460 volt motor, (4) a...

0.75" Brabender Extruder, 25:1 L/D, Model 2503

• Manufacturer: Brabender
• Model: 2503

0.75" Brabender Extruder, 25:1 L/D, Model 2503 Used 0.75" Brabender extruder, model 2503, 25:1 l/d, electrically heated, 3 barrel zones, 1 die zone, 3 hp motor, with control panel, 230 volt, serial# 1313.

Hartig SHJ-72 Plastic Extruder Package

• Manufacturer: Gentec

Extruder Guards Heater Control Box: Phase Convertor Motor: Quenching Trough: