- Trusted Seller
JOHNSON
- Manufacturer: Johnson
Used Johnson roll pull roll stand Has (2) 54" x 8" diameter rubber covered rolls Rolls are driven by 10 hp DC motor Drive-All 4-speed gearbox Air actuated top pull roll
Hainesport, NJ 
JOHNSON 1.5 8891
- Manufacturer: Johnson
Johnson 1-1/2″ extruder, 24:1 L/D. Non-vented barrel mounted on a base for co-extrusion. 10HP DC motor with no controls. S/N 7619-15. 11.32:1 gear box, 41 HP with a 1.25 service factor. No barrel cooling.
Elk Grove Village, IL
JOHNSON 1.5″ 8786
- Manufacturer: Johnson
Johnson 1-1/2″ extruder 24:1 L/D, non-vented barrel mounted on base for co-extrusion. 10HP DC motor with no controls. 11.32:1 gear box rating at 41HP with a 1.25 service factor. No barrel cooling. S/N 7621-15
Elk Grove Village, IL
JOHNSON 8″ X 30 TWO 16936
- Manufacturer: Johnson
Johnson two roll pull roll stand driven by a “Drive-All” 3HP DC motor and gearbox. Pull rolls operate at 1.0, 2.07, 5.058, and 10.651:1 ratios. Pull rolls are 8″ diameter x 30″ wide and have not been used since r...
Elk Grove Village, IL
JOHNSON 54 X 8 PULL 18800
- Manufacturer: Johnson
Johnson roll pull roll stand. Two (2) 54″ x 8″ diameter rubber covered rolls. Rolls are driven by an approximate 10 HP D/C motor through a “Drive-All” four speed gearbox. Air actuated top pull roll.
Elk Grove Village, IL- Trusted Seller
Johnson 62"
- Manufacturer: Johnson
Used 62" Johnson "Spartan" sheet die. Serial #1302-69. Has an integral upper flexible lip and a fixed lower lip. Coat hanger tear drop manifold. 3/4" back center fed entrance. Set up .000 to .030 lip opening. Pro...
Hainesport, NJ 
EXTRUDERS 100491
- Manufacturer: Johnson
Hp: 25 | L/d: 24:1 | Qty: 1 | Vented: NO | Cooling: WATER | Heat type: ELECTRIC | Control type: NO | No. of zones: 4 | Screw diameter: 2" | Screen changer y/n: N
Cleveland, TX
Tip: Enter manufacturer, model or keyword