Used controller in Canada

Denver No. 18 Special Flotation Cells

• Manufacturer: Denver

Manual Cell to Cell Flow Control Gate Naturally Aspirated Sealed Standpipe

Gemeni GT250 Concentrating Table

• Manufacturer: Gemeni

VFD Controlled Overall Dimensions: Capacity: up to 115kg/hr. (250lbs/hr.) | Voltage: 110 Volt | Length: 80in | Width: 53in | Height: 56.5in | Recommended feed density: 60-70% Solids w/w | Feed size: 800 - 1000 Mi...

Denver No. 18 Sub-A Flotation Cells

Bank of 10. 18 cubic feet per cell. Sealed stand pipes. Forced air control valves. Cell to cell flow control gates. Sand relief bushings 7.5 hp motors - two cells/motor. Overflow discharge paddle shaft. Belt guards.

Mill, SAG, 32' x 12', Hardinge-Koppers, 6800 HP Dual Drive #D744636

• Manufacturer: Hardinge

32' x 12' SAG mill, manufactured by Hardinge-Koppers, driven by dual GE 3400 HP 4000 V, 60 Hz AC wound rotor induction motors, model 108770. Complete with trunnions, trunnion liners, girth gear, pinion assemblies...

Goldfield Goldtron Concentrating Table

• Manufacturer: Goldfield

Water Sprayers: Adjustable Rate Sluice Run Vari-Drive Motor Speed Controllers: Power Requirements: Overall Dimensions:

Knelson KC-CVD32 Centrifugal Concentrator

Continuous variable discharge. Fully automated control system. 40 hp baldor electric motor. Includes guarding, piping package, and spec sheet.

Eimco 6 x 6 Disc Filter

• Manufacturer: Eimco

6 ft. dia. x 6 ft. wide. Electric drive motor. Manual speed control. Right angle gear reducer to main drive. Presently fitted with 3 sets of discs.

New Surplus Knelson XD70 Centrifugal Concentrator

• Manufacturer: FLSmidth Knelson Concentrators

Piping and Instrumentation Assemblies Including: Bowl Motion Proximity Sensor and Speed Transmitter Fluidization Water Flow Monitoring with a Magnetic Flowmeter c/w Transmitter Water Control Valve c/w Actuator an...

Denver No. 18 SP Flotation Cells

• Manufacturer: Denver

Bank of 2 Cells Cell to Cell Flow Control Gates Paddle Shaft Overflow Naturally Aspirated Open Stand Pipes Electric Motor Drives the 2 Cells Overall Dimensions:

Denver Sub A No. 21 Flotation Cells

Bank of 4. 40 cubic feet per cell. Open stand pipes with forced air adapter housing. Cell to cell flow control gates. Launder trough and paddle shaft. 7.5 hp electric motor. Two cells per motor.

Outokumpu OK3 Flotation Cells

1 Bank Of 2 Cells. 3 Cubic Meters (105 Cubic Ft.) Per Cell. Feed Box. Over Flow Discharge. Float Style Level Controller. Tails Box With: 1 - Automatic Dart Valve. 1 - Manual Dart Valve. 20 Hp 575 Volt Motor.

Denver No. 24 Flotation Cells

• Manufacturer: Denver

Bank of 4 Units Paddle Shaft Overflow Flat Belt Drive through a 32-1 Right Angle Reducer Cell to Cell Control Gates 10HP Electric Motor per Two Cells V-Belt Drive With Trough 216in Long x 14in Deep Overall Dimens...

#18 special Denver Flotation Cells

Bank of 4 Denver #18 special flotation cells. Sub "A" style. 24 cubic feet per cell. Sealed stand pipes. Cell to cell flow control gates. 10 HP motor per 2 cells. Overflow discharge paddle shaft. Belt guards. Sup...

(2) Westpro Machinery FLO.2-6 Flotation Cells

• Manufacturer: Westpro Machinery

Cell Dimensions: Overflow Discharge with Stainless Launder Each Flotation Mech. comes with Deublin Rotary Air Feed Belt Driven by a 1HP Motor With Manual On/Off Switch Cells are Made of Stainless Steel Setup on a...

Hardinge-Koppers 12 x 5 Sag Mill

• Manufacturer: Hardinge

Self-Aligning Bearings Bearing Sole Plates Single Helical Bull and Pinion Gear Louis Allis 250HP Electric Motor Control Panel Falk Parallel-Shaft Gear Reducer Air Clutch Internal Grate Discharge External Trommel ...