Used accessories

Agilent/Keysight 86210A
- used
- Manufacturer: Agilent - Keysight
The 86210A has + 13 dBm maxmum calibrated output power levelled to ±0.25 dB. Accuracy is ±7 MHz in CW mode and ±10 MHz in all sweep modes. A special frequency adjustment control lets you maintain frequency calibr...
Farmingdale, NJ
Agilent/Keysight 86250D
- used
- Manufacturer: Agilent - Keysight
- Model: 86250D
The Model 86250D is plug-in for the HP Model 8620-Series Sweep Oscillator mainframes. The plug-ins consists of a fundamental oscillator and associated drive circuitry for tuning. The RF output of the instrument i...
Farmingdale, NJ
Agilent/Keysight G870A
- used
- Manufacturer: Agilent - Keysight
The HP Model 870A tuner is a waveguide slotted section with an adjustable probe mounted on a precision carriage. The position and penetration of the probe is adjusted to set up a reflection which effectively canc...
Farmingdale, NJ
Agilent/Keysight X424A
- used
- Manufacturer: Agilent - Keysight
- Model: X424A
The Model 424A Crystal Detectors are designed for use in waveguide systems in the measurement of relative microwave power upwards to 100 mW in the range from 2.6 to 18.0 Gc. Output polarity of the detected signal...
Farmingdale, NJ
Agilent/Keysight X382A
- used
- Manufacturer: Agilent - Keysight
- Model: X382A
The attenuation value of this direct-reading, precision attenuator depends on the rotation angle of the resistive card, rather than on the resistivity value of the attenuating material. Therefore, it is insensiti...
Farmingdale, NJ
Agilent/Keysight 04287-60111
- used
- Manufacturer: Agilent - Keysight
The A6 test head receives the stimulus signal from the A3 source board through the RFOUT port and test cable, and applies it to the DUT (device under test). At the same time, the test head sense two signals that ...
Farmingdale, NJ
Agilent/Keysight N4697F (N4697-60100 & N4697-60200)
- used
- Manufacturer: Agilent - Keysight
The N4697F set contains two cables. Each is shorter than the N4697E cable. Use the N4697F cables when a DUT is connected between cable ends. NMD Connectors NMD denotes a connector that has larger than standard co...
Farmingdale, NJ
IFR/Marconi 54421-003
- used
- Manufacturer: Marconi
Cal: Calibration Available | As-is: Unit Sold AS-IS | J: 54421-003J
Farmingdale, NJ
Narda 8718B
- used
- Manufacturer: Narda
- Model: 8718B
RF Survey Meter A8732d: E-FIELD PROBE | As-is: Unit Sold AS-IS | A8722d: Frequency Response Weighted E-Field Probe 300 KHz - 50 GHz | A8742d: Frequency Response Weighted E-Field Probe 300 KHz - 3 GHz | Cal: Calib...
$1,313 USD
Farmingdale, NJ
Agilent/Keysight Z4462A
- used
- Manufacturer: Agilent - Keysight
Keysight Z4462A Fast Ethernet LAN Probe As-is: Unit Sold AS-IS | Cal: Calibration Available
Farmingdale, NJ
Agilent/Keysight E5503B
- used
- Manufacturer: Agilent - Keysight
- Model: E5503B
The E5503B phase noise measurement solution simplifies ATE test times for one-port VOC''s, DROs, crystal oscillators and synthesizers and maximizes capability for R& D benchtop applications. The Agilent E5503B ph...
$9,950 USD
Get financing
Est. $195/mo
Farmingdale, NJ
Agilent/Keysight 3200B
- used
- Manufacturer: Agilent - Keysight
- Model: 3200B
The 3200B VHF Oscillator is designed for general purpose laboratory use in the frequency range of 10 to 500 MHZ. Typical applications include: receiver and amplifier testing,; driving bridges, slotted lines, ante...
Farmingdale, NJ
Agilent/Keysight 21364A
- used
- Manufacturer: Agilent - Keysight
The Philips 21364A Transesophageal (TEE) transducer has a frequency range of 3.7 MHz. - 5.0 MHz. and supports the following applications: Transesophageal. The Philips T5012 (21364A) transducer is compatible with:...
Farmingdale, NJ
Agilent/Keysight N8975AZ
- used
- Manufacturer: Agilent - Keysight
- Model: N8975AZ
Agilent N8975AZK-K63 50 GHz to 63.5 GHz Block downconverter WR 15 connector (for use with N8975A)
$24,098 USD
Get financing
Est. $454/mo
Farmingdale, NJ
Agilent/Keysight N4373D
- used
- Manufacturer: Agilent - Keysight
The new N4373D offers the latest N5227A series network analyzers with 2-port or 4-port configuration. This LCA is the ideal measurement solution for test of electro-optical components up to 67 GHz. It is the idea...
Farmingdale, NJ